There are several sets of holes for mounting the board more toward the back or front. Choose the mounting setup that fits your needs/desires. Additionally, play with the OpenSCAD source to make it work for you. Support should not be necessary, as the overhang for the snap in is very small. The OpenBeam extrusion reference used to make this (openbeam.dxf in OpenSCAD source) can be found here: http://www.thingiverse.com/thing:100960/#files
Bill of materials & Instrucions
- PLA/ABS
- 4x of the following
- M3x8mm SHCS
- Washers
- 8x hex nuts
Screw stack-up from bottom-up:
- M3 x 8mm SHCS (pressed in)
- Printed plate
- Hex nut
- Washer
- Azteeg X5 PCB
- (Optional, swap screws for 10mm length) washer
- Hex nut
License: CC0 1.0, Public Domain Dedication