Use tree and normal support on the same object

[Surpixx]

Idk if its even possible to add but i had several objects already that would be printed best with the use of normal and tree supports in different places. Maybe add a function like paint on supports so you can decide wich parts should get normal supports and which get tree supports.

[LJKraus]

Tree Hybrid does use normal supports under flat areas, and tree for the rest. No control over which areas get which support.

[DARKFiB3R]

The image posted below is using hybrid 🤷🏻‍♂️

[Surpixx]

Didnt know that, while trying different support settings it didn´t put normal supports under the flat areas so i assumed it doesn´t work that way.
Then maybe add the option to decide which areas should get which type of support, either by painting the areas or by determination of an area size and if an area is below the value, tree support are used otherwise normal supports will be generated.

edit: i just tried in BambuStudio and there it is putting the right types of support unter my print...

[DARKFiB3R]

If it could switch to a different type of support at the point marked in this image, I think it could shave a noticable amount of time off the print.

All those tiny circles take ages, and are a potential point of failer (though they have worked without issue for me), so bridging across them earlier in the print could result in a cleaner recovery, right?