THANK YOU for automatically loading the printer.

[Ecks32]

I had posted in the Bambu Lab forums about how annoying it was that BS would forget which printer I selected whenever I changed tabs. I had also asked if it was possible for it to automatically load the printer since I only have the one. Only answer I received is that it had been broken in an earlier release.

Well you fixed it. Not only does it remember the the printer when changing tabs but it also loads it on start up. I didn't realize how handy that was until it actually started working. Now I don't have to remember that thing I usually would forget.

There is one other annoyance I would like to see fixed but it's not part of the Orca so I doubt you can fix it. The way Orca Slicer sets itself on top of all other windows and blocks access to the task bar. Bambu Studio did it as well and it's highly annoying when I need to get back to source folders to make sure I'm loading the correct models and so on. I made a little bar of buttons that sets over the window title that I can click to send keyboard shortcuts when the keyboard isn't handy. I assigned one of these buttons to show the taskbar when Orca is blocking it. It keeps me sane.

Thanks again for the wonderful upgrades.