Here are some of the modifications made to this configuration:
- 300x310x350 build volume (Z reduced from 400 to prevent the bowden tube from flexing against the top bar)
- Proper steps/unit configuration
- Adjusted default feedrate and acceleration
- PID for the hotend and bed
- BLTouch wired on Z_MAX with proper offset and 2 probe for each point
- Bilinear leveling with a 5x5 mesh (segments length increased to 20mm)
- Leveling restored after G28
- Z safe homing
- Nozzle park
- Advanced pause with park on pause and filament unload G-codes
- Filament runout sensor without automatic filament unloading
- EEPROM settings storage
- Print statistics
- SD card support
- Power loss recovery
- Babystepping (with Z offset adjustment)
- Classic jerk
- S-Curve acceleration
- Disabled arc support
The following is also enabled to help with OctoPrint setups:
- Higher baudrate (250,000)
- Host action commands with host prompt support
- Emergency parser
- Advanced OK