Condor soaring simulator (v2) ref: www.condorsoaring.com/ ref http://www.condorsoaring.com/manual/ UDP data Checkout current issue of Sailplane and Gliding, August-September- 5 pages of experiments, false trails...

Simple program that collects the Condor UDP output and converts it to output to a serial port so the Condor Data can be processed externally.

Basis for a homesim

Condor --> Arduino
Arduino --> Condor is not possible yet
Map keys, joysticks etc for inputs in a HID compatible device Generic UDP output

Condor can stream data to external applications using UDP protocol. UDP.ini

UDP output is enabled by setting »Enabled=1« parameter in the »UDP.ini« file found in Condor installation directory:

[General] Enabled=1

[Connection] Host=127.0.0.1 Port=55278

[Misc] SendIntervalMs=1 ExtendedData=0 ExtendedData1=0 LogToFile=0

In the same file host address and port are also set. Send rate is controlled by SendIntervalMs parameter which specifies the time interval between two consecutive data packets. Some additional parameters are available if ExtendedData or ExtendedData1 are enabled. The output can also be logged to file for debug purposes by setting the »LogToFile=1« parameter. UDP Packet data

The data packet is an ASCII stream of ‘parameter=value’ pairs with the following parameters

time in-game display time decimal hours slipball slip ball deflection angle rad altitude altimeter reading m or ft according to units selected vario pneumatic variometer reading m/s evario electronic variometer reading m/s nettovario netto variometer value m/s integrator integrator value m/s compass compass reading degrees slipball slip ball deflection angle rad turnrate turn indicator reading rad/s yawstringangle yawstring angle rad radiofrequency radio frequency MHz yaw yaw rad pitch pitch rad bank bank rad quaternionx quaternion x / quaterniony quaternion y / quaternionz quaternion z / ax acceleration vector x m/s2 ay acceleration vector y m/s2 az acceleration vector z m/s2 vx speed vector x m/s vy speed vector y m/s vz speed vector z m/s rollrate roll rate (local system) rad/s pitchrate pitch rate (local system) y rad/s yawrate yaw rate (local system) z rad/s gforce g forces / height * height of cg above ground m wheelheight * height of wheel above ground m turbulencestrength * turbulence strength / surfaceroughness * surface roughness / hudmessages * HUD message text separated by ; flaps ** flaps position index : 0=most negative to MAXFLAPS-1 MC ** MacCready setting m/s water ** Water ballast content kg Please note: The hudmessages do not show properly. I suspect a bug with Condor. I have sent an email to Condor

docop/Condor2Arduino

ErrorLooks like something went wrong!

About

Resources

Uh oh!

Stars

Watchers

Forks

Releases

Packages 0

Uh oh!

Languages

Error
Looks like something went wrong!

Packages