Make sure tinytemplate symlink is pointing to a directory which contains checked out tinytemplate repository. By default symlink points to a sibling directory of this repository. Commit id of the repository is specified in the contents of symplink.
Makefile accepts the following arguments:
| Argument | Possible Values | Notes |
|---|---|---|
| name | ptx|prx | Binary (primary transmitter or primary receiver) to build |
| avrType | attiny85|attiny2313 | Controller type. Tested only with attiny85 |
| dudeHost | alarmpi|... | When specified runs avrdude on the specified host |
Most common make commands are elf (compile) and flash (compile and write to MCU). Flashing is done using a Raspberry Pi which has MCU connected via SPI.
For example, the following command would compile primary transmitter and flash it to ATtiny85 connected to Raspberry PI running as alarmpi2:
make name=ptx avrType=attiny85 dudeHost=alarmpi2 flashCode assumes three wire setup where CSN clock is held by a capacitor and is controlled by SCK pin before and after transfers.
Logging is enabled via UART on PB4.