EMMC BOOT

[Siburanjan]

I have builded the image by downloading the source file but when I move the raw file to the USB armory mk ii device and load it using the specified command into the emmc and removing the sd card and booting up the device its not booting up can you please help me out with that also the u-boot is not available

[abarisani]

The build instructions indicate that the BOOT variable must be set accordingly.

We haven't tested, or supported, moving an image to a different media and boot it up.

Can you show the command you are using? How are you issuing the command?

Thanks

[Siburanjan]

then is the image to be builded in the usbarmory device itself ? I moved the image file builder in my host system to the device using scp and then hitted the following command "sudo dd if=usbarmory-mark-two-emmc-debian_bookworm-base_image-20250326.raw of=/dev/mmcblk1 bs=1M conv=fsync"

[abarisani]

There is no requirement to build the image on the device itself.

Only the raw image must be copied on the right target.